30mm REAR AXLE MOUNTING INSTRUCTIONS
Certain steps have to be followed when mounting a 30mm rear axle to make sure it will not move.
Before fixing the axle, make two small holes (4.5mm) with the drill bit to make sure the grup screw goes perfectly into the hole and does not move.
You can now proceed and strongly tighten-up the grub screws into the axle; this operation will prevent the axle from moving and consequently cause mechanical problems or a poor chassis performance.
Also you may use a very small point of BLUE “Locktite” to prevent vibrations from unscrewing the grub screws (DO NOT EVER use red Locktite).
